Drychem Two Component Epoxy Grout is low VOC epoxy tile grout. It is two component system, the resin blended with selected fine fillers and the hardener. It is supplied in pre-weighed quantities, ready for on-site mixing and use. Drychem Two Component Epoxy Grout is stainless, chemical resistance, high performance epoxy grout.
Features
Easy to use
High strength
Stain free
Water resistant
Wide range of colours
Rich & beautiful looks
Details:
Nature
Part A: Coloured paste Part B: Amber colour liquid
Composition
Part A: Epoxy resin with graded fillers Part B: Hardener
Mix ratio (A : B)
92 : 8
Setting time @ 30°C
24 hours
Foot traffic @ 30°C
24 hours
Heavy traffic @ 30°C
72 hours
Pot life @ 30°C
Minimum, 30 minutes
Full cure
7days
Compressive strength, MPa
Minimum 30
Tensile adhesion strength, MPa
Minimum 2 (on concrete surface)
Flexural strength, MPa
Minimum 10
Shrinkage, %
Negligible
Guidance For Application
SURFACE PREPARATION 1- Before starting to grout, remove debris in grout joints and dust can be removed by compressed air jetting. Ensure water, oil, dirt and other contamination-free joints. 2- Remove dirt and dust from tile surface by cleaning with sponge. Do not clean the tiles with acids. 3- The prerequisites for good adhesion of the grouts are cleanliness and roughness of surface. 4- Unless these are ensured by proper surface preparation a successful performance cannot be guaranteed. 5- The substrate and application temperature must be between 16°Cand 32°C.
MIXING 1- Mortar is prepared by mixing the base and hardener in the given ratio. 2- Pour the entire contents of base in a clean vessel, then pour entire contents of hardener and mix thoroughly till a lump free uniform paste is obtained. 3- This grout paste is workable within 30-40 minutes @ 23°C 4- Press the grout firmly by using a hard rubber squeeze into the joint ensuring that the joint is completely filled.
APPLICATIONS 1- Use standard epoxy grouting techniques to work the tile grout in the tile joints. 2- Ensure that the entire joint is packed fully with the material. Remove the excess grout material from joints and surface by moving the squeeze diagonally to the grout line.
Cleaning:
Wipe the strains on the tiles with water when the grout is partially set.
Using sponge clean off the grout from tile within 40 minutes before it dries.
Clean the grout haze from the tile with clean water or soap solution within 24 Hrs.
